MTSKR20WF V2 Remote Control for Electric Skateboard

MTSKR20WF V2 Electric Skateboard Remote Control

Features

• Bidirectional communication 2.4GHz, 40 channels, automatic frequency modulation to prevent interference;
• Communication distance of 20 meters; 16 hours of operating time after a full charge;
• Built-in lithium battery 420mAh with USB port for charging;
• Color OLED display 128x64;
• Easy switching between fast and slow riding;
• Automatic throttle calibration on power-up;
• Communication drop alert between the remote and receiver; if the signal is lost for 5 minutes, the remote will automatically turn off to save battery;
• If the signal is lost between the remote and receiver, the receiver will disable the throttle for rider safety;
• Memory code function, the remote and receiver connect quickly after power on;
• Switching function for forward and backward motion *

Note: Functions marked with an asterisk (*) are available with the dual ESC regulator MTDU30A.

Specifications:

• Model: MTSKR20WF V2
• Remote control battery: 3.7 V 420 mAH
• Frequency: 24 GHz
• Output power: 7 dBm
• Operating current: 26 mA
• Operating time: 16 hours
• Control range: >20 meters
• Display: 128 x 64 OLED
• Wireless charging
• Three adjustable speed modes
• Speed and distance display
• Battery capacity for remote control and skateboard
• Double trigger control
• Compatible with: VESC4/VESC6/FOCBOX/PWM ESC
• Throttle output: PWM 1ms-2ms 100Hz
• 30V 3A Mechanical relay
• 20V 2A transistor relay
• Extended antenna: yes
• Waterproof: IP66
• Receiver weight: 11g
• Transmitter weight: 96g

1. Rinse the remote control in fresh water after using it in seawater.

2. The remote control PCB is sealed with a waterproof nano-coating and is double protected with adhesive. The remote control display is sealed with a waterproof nano-coating, not adhesive. When used in water, water may get between the outer and inner screens. This will not affect the use. When not in use, store in a dry place to allow it to dry slowly.

3. When charging the remote control, please keep it dry.

4. The receiver is not waterproof. Please place the receiver in a dry location.

5. As each customer situation varies, some may need to replace the antenna with a longer one. If you mount the receiver deep in your board, we recommend switching to a long 2.4GHz antenna and leading the antenna to the top cover of the board for better signal.

6. When soldering, please take care that two pins do not touch, otherwise you may easily burn out the receiver.

7. 1m and 3m PCB extension antennas are not waterproof.

Package Contents: